arreche atomizer

[90GTVert]

Let me start off by saying this : I did receive your message. I read it at probably 1-2AM when I just checked in one last time before bed one night to make sure the forum wasn't on fire or anything. Meant to get to it sooner. There are 6,000+ people here. I have 7,000+ subscribers on YouTube. I get emails from people that aren't on the forum or YouTube and just want help. I have a lot of questions. This month I've had a huge surge of PMs. If I try to catch up on the forum, more PMs are popping up. I'm doing my best to keep up and help where I can.

Add to that I've had problems with my hip and lower back for over a week now and to get to the carbs I have to get down and pull heavy boxes out of the way. I'm uncomfortable day and night with my hip and back, so I haven't had a great desire to aggravate it.

That said, today... before all of this nonsense calling me out for not trying to help you... I did it anyway and took some pics of what's in my Arreche. I'm trying here, but remember this is free help. I've never asked you for anything. While trying to get pics, I then get farther behind on everyone else's questions.

I never forgot about you. I probably should have sent you a PM to let you know I'd get to it sooner or later at least.

Now I went through all of this and was just getting ready to upload a bunch of pics for you and realized you're the same person I've banned at least 10 times for cursing people, being demanding, claiming no one but you understands anything, etc... So with that, I bid you adieu.... at least till you sneak in again with another name and IP address because no one else will help you at all.

[90GTVert]

I'll upload what I have here anyway so you can see it at least, as I'm sure you'll check back in and you don't need to be a member to read this. Hopefully it is of some use.

This is what's in my carburetor. It appears to match the top one that you posted, but there are measurements just in case they're of use.





I initially thought the one in your pics just had the atomizer bushing stuck on it. Here's the atomizer bushing on mine.



I removed it so you could check it out. The first pic is looking up through the bottom of the carb. You can see a black ring, that's the bottom of the bushing. I stuck an M6 bolt in there, large enough to contact the bushing and small enough to fit past the threads, and it popped out with one light tap.







It went back in with a gentle push from the top, being sure to align the open side so it faces the engine.

You can see it's clearly not just an atomizer bushing stuck on the end of yours. The bushing is way larger than the atomizer.



The carb that these came out of is an Arreche 19mm purchased for a Minarelli engine (they had different styles for direct fit to different platforms). The place that I bought it from is no longer around, but I have a feeling Provoscooter or Moped Hospital would be able to help you.



A few more pics of the Arreche here if needed :
49ccscoot.proboards.com/thread/366/installing-19mm-arreche-carburetor

[2TDave]

How's that carb tuning going Richard?