|
|
Post by viper0463 on Apr 19, 2014 20:38:34 GMT -5
So I blew the motor in my eton beamer II. I'm thinking about putting in a 1PE50QMF. I have access to one in very good condition. I already was told I would have to swap my stator for the one currently in the 90 is that true? What performance exhaust can I get thats not over priced under 150 would be good or a used one (hint, hint guys). I will need a carburetor also and have no idea what I should get. What else will I need to swap this thing? It's complete except exhaust and carb. Thanks
|
|
|
|
Post by moofus02 on Apr 19, 2014 23:14:14 GMT -5
You could use your stator with the flywheel from the new motor. Carb off of yours would work as well as your stock exhaust to get you going just have to jet the carb. Not perfect but will work
Sent from my SPH-L720 using proboards
|
|
|
|
Post by 90GTVert on Apr 20, 2014 13:54:59 GMT -5
If you want to upgrade the carb at some point a 21mm DellOrto PHBG or a clone of it works well. They fit the stock intake and airbox. Remove the snorkel from the airbox so it gets plenty of air. 2strokd did a write up about using the stock cable with one : 49ccscoot.proboards.com/thread/6391/installing-dello-style-carb-cableThere are usually some pipes for 100cc minarellis on eBay or a 70cc Leo Vince ZX works OK. The best pipe I know of for a street 90-100cc is hard to get ahold of. It's made by Phongeer. VT Cycles may be able to get them. 100cc stuff is getting harder and harder to find. |
|
