KX 65 Pipe Modded for Mina

[drawkward]

Been looking around at making a new pipe. If any at all, what would be the reason not to pick up one of these off eBay for under $50 shipped, and hack it up to fit my mina?

cgi.ebay.com/ebaymotors/Kawasaki-kx-85-stock-pipe_W0QQcmdZViewItemQQcategoryZ35581QQitemZ280383189700#ht_500wt_956

[90GTVert]

I have to wonder if it would be anywhere near the original by the time you managed to get it to fit.

[reveeen]

From what I understand: you just cut through the sections, rotating them to fit, then weld them back together.

Probably better suited for a vertical engine (Dio etc), but never say never.........

Might be a bit higher in the power band than is optimum on a scooter.

Cr80/85 pipe is good for this too.

[190mech]

I did a CR80 a while back,results were a lot of work and a gutless pipe!These pipes are tuned for a super wild ported cylinder with a close ratio gearbox,which we have neither of!!

[2strokd]

Man those lil suckers will fly tho!
I had a YZ80L/C that was fun.