|
|
Post by beamerstunting on Apr 11, 2011 14:28:26 GMT -5
ohh ok well iam still talking about the beamer 3 and ive order the BBK 10mm and i was thinking about the 2k clutch and torque spring to give me the torque i want off the line
the beamer 3 rollers are 15x12mm right and i should get the round ones not the polygon set
I was also looking at the proformance clutch from scrappydog and proformance varitor from there too
|
|
|
|
Post by preytheweak on Apr 16, 2011 4:59:54 GMT -5
Just some advise. Not all so called 2k clutch spring and contra springs are the same. Some are very stiff like a white Koso 2k spring. Most are red and very in stiffness. I've had alot of them. All of them acted diff it the scooter using the same roller weights. But before all of this I would get a good variator first. On that has a steep angle on the back plate for more top end. Then adjust the RPMs you want to shoot for buy changing the weights on the rollers. Then depending on what contra spring is in the depends on how long it takes to go in to the lower part of the pulley. And a stiffer contra will also force it closed faster. Buy a digital tach. IRS a good investment. I run the stiffest contra I could find then play with the rollers until I achieve the RPMs I want to hit at a given speed. It's going to depend also on the cylinder and pipe you run also. Diff. power ranges.
I do no one thing your setup not be like any one else. If you tweak it out to get the most out of the CVT and you cylinder.
Also I would get a 21mm carb for it. Let that cylinder breath and it will run cooler and better. Plus a pipe that is design for a 70cc is alot better also.
|
|
