|
|
Post by benji on May 20, 2018 9:45:59 GMT -5
It did run fine for a very short amount of time before either was parked. Bike has very few miles. Seems to have good petcock/filter flow, tried running w no muffler and it was the same. Currently has "stock" jets (still not convinced this is the OEM carb) and it's had it's valves adjusted. I'm about to swap a 2t motor or gy6 in it and sell it
|
|
|
|
Post by benji on May 20, 2018 9:47:14 GMT -5
Lotta smoke when it does run too.
|
|
|
|
Post by fly on May 22, 2018 23:26:16 GMT -5
Any chance it doesn't have the correct oil in it?
At least run it and check the pug. Sounds way rich. Wonder if they put in the wrong oil.
|
|
|
|
Post by kagetenshi on May 23, 2018 18:58:12 GMT -5
The only way I could see the wrong type of oil causing a problem is if it was either way too thick or way too thin. These small scoots usually call for 15w-40, which is used in diesel engines mainly. They have a bit of wiggle room though.
For instance, I was doing an oil change in mine a few summers ago and I swore I had a bottle of 15w-40 from Royal purple sitting in my closet, but all I had was some left over 10w-30 from the last time I changed my cars oil. So I used it. It got me to the auto zone and back without showing any signs of smoke or overheating. That was roughly a 7 mile round trip in 90+ degree weather.
|
|
|
|
Post by benji on Nov 15, 2021 17:36:28 GMT -5
Got me another. A Yamaha Riva xc180  |
|
|
|
Post by benji on Nov 15, 2021 17:37:43 GMT -5
|
|
|
|
Post by benji on Nov 15, 2021 17:38:35 GMT -5
This is my first maxi-scooter. I already wanna sell it 🙄 don't run, gotta put the carb back on and hope it runs.
|
|
|
|
Post by aeroxbud on Nov 15, 2021 20:21:23 GMT -5
Good luck.
|
|
|
|
Post by benji on Nov 19, 2021 16:36:35 GMT -5
Picked up another Zuma. It's missing some cvt parts. Anybody have a minarelli rear pulley and clutch laying around?  |
|
|
|
Post by Happypancake! on Nov 19, 2021 17:37:36 GMT -5
 These are ….. maybe from a gy6 |
|
|
|
Post by benji on Nov 20, 2021 9:28:37 GMT -5
These are ….. maybe from a gy6 ...could work maybe 🤔 cuanto mas quieres amigo |
|
|
|
Post by geoffh on Nov 20, 2021 10:34:29 GMT -5
I have numerous Yamaha clutches and pulleys that may fit, your welcome to them gratis but I am in the UK shipping is the problem.
Geoff
|
|
