zoomzoom
Scoot Member
Posts: 21 
Location: Las Vegas
|
Post by zoomzoom on May 7, 2016 10:09:14 GMT -5
I couldnt find anything on these heads so im building a +6mm stroker with a 61mm kit and 4 valve from scrappydog.
|
|
|
|
Post by jkeney on May 7, 2016 17:49:41 GMT -5
Please do!
|
|
zoomzoom
Scoot Member
Posts: 21
Location: Las Vegas
|
Post by zoomzoom on May 8, 2016 16:29:22 GMT -5
posting some pictures up of the head and piston while I wait until tomorrow to go get the longer qj timing chain good thing i have to regasket this engine anyways.
|
|
|
|
Post by stepthrutuner on May 8, 2016 20:06:46 GMT -5
Yippy. Muscle mania.  Cubes to the rescue.  |
|
zoomzoom
Scoot Member
Posts: 21
Location: Las Vegas
|
Post by zoomzoom on May 16, 2016 22:22:55 GMT -5
|
|
|
|
Post by kagetenshi on May 16, 2016 23:31:34 GMT -5
Streamlined as hell. Should do up the scoot nicely.
|
|
|
|
Post by vlatx on May 17, 2016 11:40:05 GMT -5
Nice one,what carb are you going to run on it,and pipe?
|
|
zoomzoom
Scoot Member
Posts: 21
Location: Las Vegas
|
Post by zoomzoom on May 18, 2016 1:14:21 GMT -5
a 30mm pumper carb to get it running and then probably a 28mm koso flat slide. The pipe is go to be a homemade exhaust so it'll match the porting on the head.
|
|
|
|
Post by vlatx on May 18, 2016 11:34:25 GMT -5
Flat slide carb is a go,and 28mm i think it will be ok,dont go over 20mm Ф on the pipe,and try to make adapter so you can alter the ignition.
|
|
Cubes to the rescue. 
