|
|
Post by remcosuper8 on Dec 13, 2017 14:19:42 GMT -5
Hi everybody.
My name is Remco and i am from Holland and i am riding a Kymco Super 8 with a naraku 47mm bbk and a Touring camshaft.
I also changed the variator to a malossi.
I am here because i have some belt issues and some questions about the gearing of the super 8 but i will open a thread for that.
|
|
|
|
Post by milly on Dec 13, 2017 15:41:41 GMT -5
Hi
|
|
|
|
Post by diynuke on Dec 13, 2017 16:15:22 GMT -5
Hi everybody. My name is Remco and i am from Holland and i am riding a Kymco Super 8 with a naraku 47mm bbk and a Touring camshaft. I also changed the variator to a malossi. I am here because i have some belt issues and some questions about the gearing of the super 8 but i will open a thread for that. well eh welcome i kind of have a very similar setup ;D Kymco agility 72cc naraku A9 performance cam no rev limit cdi malossi multivar variator and performance exhaust. i am running main jet 88 now 90 was too rich so every 3000km i had to do an valve job. ;P where do ya live ? i live in Alphen aan den rijn Zuid-Holland. |
|
|
|
Post by remcosuper8 on Dec 13, 2017 16:36:19 GMT -5
I am from Bergen Noord-Holland.
And i do use the 90 main jet and no problems with my valve adjustment maybe because i still have the original cdi.
i just wanted more pulling power not higher top speed
|
|
|
|
Post by aeroxbud on Dec 13, 2017 18:31:43 GMT -5
Welcome Remco
|
|
|
|
Post by gsx600racer on Dec 14, 2017 3:30:07 GMT -5
 Iv checked a couple of my go to sources for parts and I could not find any gear options. If the engine is based off of the generic 139QMB(Chinese clone) platform, you might find something.
|
|
|
|
Post by GrumpyUnk on Dec 26, 2017 22:29:57 GMT -5
To get more 'pulling power', you would want the variator pulley to have a smaller diameter, keeping the engine turning more for each turn of the clutch pulley. Lighter weights in the variator working against a stronger 'contra spring' would keep the belt from climbing so high in the variator(keeping it smaller) and thus reducing top end a bit with higher acceleration(pulling) under load. If that's what you want.
tom
|
|
|
|
Post by geoffh on Dec 27, 2017 11:21:13 GMT -5
Remco,welcome to the forum.Best to spend the dark nights in the tech section grumpys post is a little confusing,but I,m not a 4 stroke guy.Are your roads as flat a folk lore has it. geoff  |
|
|
|
Post by Lucass2T on Dec 29, 2017 20:27:42 GMT -5
Welkom! Scooterfreaks ook helemaal beu?  |
|
|
|
Post by Senna1Rossi on Jan 26, 2018 19:03:04 GMT -5
WELCOME!
Omloop Het Volk... I got this confused with Amstel Gold Race in the Netherlands.... heh
Oi, there's also Bergen in Norway...
|
|
