|
Post by kakio5959 on Apr 10, 2023 19:12:13 GMT -5
changed my coil and my stator and new battery i still have no spark only thing i havent changed was the cdi box need help
|
|
|
Post by RyanWiltshire on Apr 11, 2023 5:47:31 GMT -5
changed the coil along with the HT lead cap? make sure your pick up is no less than 1mm gap between flywheel and pick up, measure it with a feeler gauge.
check for power from the box and see if it's throwing the correct values or any at all. no point replacing things what aren't broke. you could even have a dodgy wire as well.
|
|
|
Post by John Kiniston on Apr 11, 2023 15:07:35 GMT -5
Do you have a multimeter? Check that the pulser coil is pulsing.
|
|
|
Post by repherence2 on Apr 11, 2023 22:24:28 GMT -5
it might be a silly question, but did you install the woodruff key when you installed the flywheel/rotor?
check the continuity of the wires going to the coil. on my chinarelli (single wire coil) the signal wire was corroded on the inside but you could not tell just by looking at the wire because the insulation was still good. it took a while to troubleshoot that.
|
|