|
|
Post by ewasleske on Jun 11, 2023 18:55:05 GMT -5
Vento triton starter not spinning. 12 volts at one side of relay. Random voltage at other side when starter button is pushed. Same result with two relays and two starters. Any ideas?
|
|
|
|
Post by oldgeek on Jun 11, 2023 19:09:25 GMT -5
Motor and frame grounds ok?
|
|
|
|
Post by ewasleske on Jun 11, 2023 21:08:20 GMT -5
Grounds look good but I will double check. Could this be a voltage regulator problem?
|
|
|
|
Post by oldgeek on Jun 12, 2023 5:45:35 GMT -5
I have learned not to say impossible, but a regulator issue would be highly unlikely to cause Estart problems. Can you kicksstart the scoot to get it running?
I would suspect the starter enable circuit, which the brake switches are part of. When the scoot is running do both of the brake levers bring the brake light on?
|
|
|
|
Post by ewasleske on Jun 12, 2023 20:43:51 GMT -5
Kickstarts fine . The brake lights up from both sides while running. Are there more than the two major ground points (frame and engine case)to be concerned with?
|
|
|
|
Post by oldgeek on Jun 12, 2023 20:49:50 GMT -5
Kickstarts fine . The brake lights up from both sides while running. Are there more than the two major ground points (frame and engine case)to be concerned with? I dont remember how many grounds there are. Did you check the small glass inline fuse that is usually near the battery? |
|
|
|
Post by ewasleske on Jun 14, 2023 21:10:13 GMT -5
Going over everything this weekend. I‘ll post the results. Thanks for the help!
|
|
|
|
Post by ewasleske on Jun 19, 2023 20:53:34 GMT -5
Solved! Turned out to be the starter. Thanks for the help OG
|
|
