|
|
Post by aeroxbud on Apr 8, 2012 19:19:03 GMT -5
|
|
|
|
Post by 90GTVert on Apr 8, 2012 21:21:25 GMT -5
Great read. I think I've ported just about all of the cylinders I've had and I knew it worked when done right, but it's cool to see the dyno results.
|
|
|
|
Post by reveeen on Apr 9, 2012 2:26:03 GMT -5
of interest to note is: remember that big exhaust shoot-out (crap-shoot) they had/have posted? and what pipe are they using? (check the dyno graph).
|
|
|
|
Post by drbenz on Dec 3, 2012 17:35:03 GMT -5
It's an interesting read period! A good reminder that there is a science to hot rodding any engine.
|
|
bare
Scoot Member
Posts: 55
|
Post by bare on Dec 16, 2012 22:39:39 GMT -5
Erm.. Where?? did you source a quality 90 degree handpiece.. that will fit comfortably into a sub 50mm Bore?
None of mine will go into less than ~53mm.
Without a decent handpiece one could just as well be using a Cold Chisel and a 5 lb :-)
|
|
hit88
Scoot Member
Posts: 43
|
Post by hit88 on Dec 17, 2012 6:41:17 GMT -5
cc specalty. thats were i get all my stuff....thanks
|
|
bare
Scoot Member
Posts: 55
|
Post by bare on Dec 17, 2012 13:48:00 GMT -5
thank you, that never occurred.
Have a medium CC handpiece, for years, wasn't aware that they've added a tiny one.
|
|
