|
|
Post by bucket6429 on Jun 10, 2012 14:51:19 GMT -5
alright i am wanting to get a bore and i found a 50mm cylinder kit do i have to buy the head to match or can i just use stock i have a leo vince uni filter an 88 jet
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 10, 2012 17:00:23 GMT -5
its best to get a bore matched head. an 88 is too small for a 50mm bore. a 95 ususally works perfect with a stock cam and stock size valves.
|
|
|
|
Post by bucket6429 on Jun 10, 2012 17:03:47 GMT -5
how much of a gain do u get from using th ehead
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 10, 2012 17:06:02 GMT -5
the gain is compression being low enough so that the starter will turn the motor
|
|
|
|
Post by bucket6429 on Jun 10, 2012 17:13:37 GMT -5
okay an it is okay to just buy this one off eaby for 65
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 10, 2012 17:24:28 GMT -5
that whole kit from robotech?
you may need an additional base gasket with that kit because sometimes the piston will hit the head......and be sure to check the oil ring gaps they should not be over .020"...because if they are it will smoke like a train
|
|
|
|
Post by bucket6429 on Jun 10, 2012 17:36:01 GMT -5
idk its 65 dollars on ebay its a 50mm
|
|
|
|
Post by abansb on Jun 11, 2012 11:22:08 GMT -5
I got the same kit and the oil rings gaps where to wide I just sent them a message and they sent me a new set of rings that worked
I also had to add a base gasket
|
|
