|
|
Post by rockie25 on Oct 11, 2012 12:23:56 GMT -5
it turns over like it wants to crank, but its not... Brand new spark plug, boot, and coil.
|
|
|
|
Post by teddy554 on Oct 11, 2012 12:39:20 GMT -5
have you tested to see if it actually sparking, you got your switch on done that before lol also make sure you have the spark plug gap correctly .7-.9and what spark plug did you put in
|
|
|
|
Post by rockie25 on Oct 11, 2012 12:44:51 GMT -5
a guy at the scooter shop did the spark plug for me.. how do i check the spark?
|
|
|
|
Post by teddy554 on Oct 11, 2012 12:51:02 GMT -5
Alright so lets get this all straighten out, when was the change in parts done and it has ran after the parts change. but the way you test for spark is to take spark plug out and leave it hooked to coil and place the tip near something metal and hit the starter button and see if you have a blueish spark. Also have you check all the minor stuff switch in run position and gas in the tank
|
|
|
|
Post by rockie25 on Oct 11, 2012 13:13:04 GMT -5
thats correct.. it ran for a day or two after the part change.. The switch is on run, there is gas in it. fairly new carb, checked the gas line, there is gas flowing
|
|
|
|
Post by teddy554 on Oct 11, 2012 13:57:12 GMT -5
Alright check to see if you have spark and also what plug did they install
|
|
|
|
Post by teddy554 on Oct 11, 2012 14:01:24 GMT -5
|
|
|
|
Post by stillgar on Oct 14, 2012 7:52:05 GMT -5
Hi,
I just got my Baja SC50 to start last week. I checked for spark by putting a phillips screwdriver in the spark plug wire cap and having the shaft near frame ground. You can see the spark that way, if you're careful. If no spark there, try holding one of the coil wires just a few thousandths away from the connector while cranking. I saw a little arc on mine.
My problem turned out to be a disconnected kill switch wire at the connector (DC stator, see my post below if you're interested).
I learned a lot about these ignition systems, having no money for a shop. It seems poverty is the mother of learning! Good luck!
-Gary-
|
|
|
|
Post by blazers10 on Nov 5, 2012 19:15:32 GMT -5
can you tell me were the kill switch is my scooter wont strart
|
|
|
|
Post by 90GTVert on Nov 6, 2012 17:51:27 GMT -5
Should be up on the right hand controls.  |
|
