Deleted
Deleted Member
Posts: 0
|
Spring!
Mar 16, 2013 16:48:51 GMT -5
Post by Deleted on Mar 16, 2013 16:48:51 GMT -5
77 Degrees in Raleigh today! Kaiyote says YIPPIE!!!! TIME TO BE OUTSIDE!!! Got the tool box from lowes $50 off because the keys for the bottom section are missing. Hope everyone has been well!
|
|
Deleted
Deleted Member
Posts: 0
|
Spring!
Mar 16, 2013 17:01:53 GMT -5
Post by Deleted on Mar 16, 2013 17:01:53 GMT -5
Finally made scootaholic status! Great way to start off the season!
|
|
|
Spring!
Mar 16, 2013 17:40:20 GMT -5
Post by 90GTVert on Mar 16, 2013 17:40:20 GMT -5
Welcome back! Looks like you've got plenty to keep you busy out there.
Not 77 here, about 50, but my dog has been enjoying some time outside too while I work on my car. Looking forward to the good scooter weather in the future.
|
|
Deleted
Deleted Member
Posts: 0
|
Spring!
Mar 16, 2013 18:31:47 GMT -5
Post by Deleted on Mar 16, 2013 18:31:47 GMT -5
Hey Brent! Yes lots to do! Did a qmb teardown and took the cranks to NAPA today for the oil pump gear swap. Just a straight forward stock crank and 50mm top end to put up on CL! How bout you?
|
|
|
Spring!
Mar 16, 2013 19:17:47 GMT -5
Post by 90GTVert on Mar 16, 2013 19:17:47 GMT -5
You use the oil pumps that come with the big bore kits or just cause of the new crank? I had a seller tell me they were just stock replacements, no need to bother.
I haven't done much with scoots lately. Got my 103 running again, didn't even tune it yet. Went to work on the Mustang. Pulling it's engine and trans soon. Wish it were a few bolts, a few connectors, and a 40 pound assembly like the scoots. lol
|
|
Deleted
Deleted Member
Posts: 0
|
Spring!
Mar 16, 2013 19:28:20 GMT -5
Post by Deleted on Mar 16, 2013 19:28:20 GMT -5
The oil pump that came with the china 50mm bbk i intend to use does not fit this motor so i will be using the original, it passed the inspection procedure outlined in Haynes #4768. To do that however the drive gear must be swapped.
LOL yeah I dont take a scoot motor out without my lift, sure wouldnt tackle a car...but ive been there done that! Taken many a vw motor out with cindar blocks and a floor jack lol
|
|
|
Spring!
Mar 17, 2013 7:52:05 GMT -5
Post by aeroxbud on Mar 17, 2013 7:52:05 GMT -5
Like your setup Wish it was that warm here
|
|
|
Spring!
Mar 17, 2013 8:42:39 GMT -5
Post by ʇwiƨtɘdburnout on Mar 17, 2013 8:42:39 GMT -5
|
|