Anyone want some carb screws? (Chinese 4T GY6 50 / 139QMB)
Sept 6, 2013 16:36:20 GMT -5
aeroxbud likes this
Post by 90GTVert on Sept 6, 2013 16:36:20 GMT -5
When I did the PDI on my TaoTao ATM50-A1, I replaced the screws in the carb with decent quality screws and lock washers from McMaster-Carr. I also purchased some washers in case I needed to raise the needle to richen the mixture, since my needle had only one groove. I bought all of it in small bulk, so I'd have some extras.
I've made up 20 sets of screws and washers. Each set is :
4 M4x0.7x14mm Phillips Head Machine Screws
4 M4x0.7x8mm Phillips Head Machine Screws
8 4mm Lock Washers
4 2.5mm Washers
If you aren't sure what you'd want this stuff for, this video should cover it...
If you want a set of these washers, PM me your address (button below my avatar to PM) and I'll send you one set. You must me a member of the forum. You must be a United States resident. Only one set per member. First come, first serve. I only have these 20 sets, so message me your name and mailing address now if you want them.
These are what fit my carb on my 2013 TaoTao ATM50-A1. I cannot guarantee that they will fit all 1P39QMB carburetors. Don't force them if they don't screw in easily.
I've made up 20 sets of screws and washers. Each set is :
4 M4x0.7x14mm Phillips Head Machine Screws
4 M4x0.7x8mm Phillips Head Machine Screws
8 4mm Lock Washers
4 2.5mm Washers
If you aren't sure what you'd want this stuff for, this video should cover it...
If you want a set of these washers, PM me your address (button below my avatar to PM) and I'll send you one set. You must me a member of the forum. You must be a United States resident. Only one set per member. First come, first serve. I only have these 20 sets, so message me your name and mailing address now if you want them.
These are what fit my carb on my 2013 TaoTao ATM50-A1. I cannot guarantee that they will fit all 1P39QMB carburetors. Don't force them if they don't screw in easily.
