|
Post by mrhooper on Jan 8, 2017 23:52:24 GMT -5
Its been rainning pretty hard the past few days it was outside for a little while until i was able to put it inside
|
|
|
Post by mrhooper on Jan 8, 2017 22:42:23 GMT -5
Sounds like tuliped valves common with cheap metal they use for valves.
|
|
|
Post by mrhooper on Jan 8, 2017 22:35:56 GMT -5
If you have a grinder cut flat spots in it. Heat it up and us a big crescent wrench to bust it off.
|
|
|
Post by mrhooper on Jan 8, 2017 22:34:00 GMT -5
It sounds like it may be a bit lean.
|
|
|
Post by mrhooper on Jan 8, 2017 22:32:08 GMT -5
My taotao 49cc was runing good for 2 weeks after I installed the bbk. Today I road it down the street to a friends house and back ran like a top. I put it in my truck drove to the neighboring city its the same atitude. Rode it down the street it ran good for about a half block and started back firing throught the carb with full throttle. It would run fine at idle and would start fine. I'm not quite sure what the issue could be I thinks it ether the timeing chain hopped a gear or the fuel has water. Any thoughts? All anwsers much appreciated.
|
|
|
Post by mrhooper on Dec 17, 2016 14:50:36 GMT -5
|
|
|
Post by mrhooper on Dec 17, 2016 14:45:29 GMT -5
Installed bbk every thing runs great. My old head had tuliped valves
|
|
|
Post by mrhooper on Dec 17, 2016 14:44:51 GMT -5
No thats my friend he was pissing in the picture.
|
|
|
Post by mrhooper on Dec 16, 2016 2:47:33 GMT -5
Here is a picture of my off road beast
|
|
|
Post by mrhooper on Dec 16, 2016 2:47:06 GMT -5
|
|
|
Post by mrhooper on Dec 15, 2016 23:41:01 GMT -5
I bought a bbk kit and a perfomance clutch that has been lightend. It has 1.5k contra and whatever the red clutch springs are. But the head that came with kit seems to be the same as stock. It is not very well machined but excpected from china. Came with 8g weights that seems a little heavy.
|
|
|
Post by mrhooper on Dec 13, 2016 1:51:37 GMT -5
Thanks for your guys responses i have changed to a 95 jet it runs better but still feels "flat" I belive the rings are worn so I will perform a compression check
|
|
|
Post by mrhooper on Dec 11, 2016 21:55:28 GMT -5
Thanks but I have a uni air filter and a white brothers racing pipe.
|
|
|
Post by mrhooper on Dec 11, 2016 21:42:24 GMT -5
I'm at sea level what size jet would you guys recommended for a A9 cam
|
|
|
Post by mrhooper on Dec 11, 2016 21:38:23 GMT -5
Yes it could. If you're off by even one tooth it will make a big difference. 50cc Sunny correct? Yes a sunny 50 cc
|
|