vento, back tire is wobbly/ "falling off"?

[brandonscoot]

so im getting kinda nervous of this new thing going on with the vento, if you grab a hold of the tire and shake it will wobble almost like if you were to check wheel bearings on a car.... it seemed to be worse after a nice burnout, the tire was gumming up and getting grip thus putting more stress on the insides. right now it works alright and evrything but when you throttle or break in a turn or leaning state it wobbles a bit. i dont like it.


an ideas on what to check?

also, i already verifyed the axle bolt is in the same position as always...

[Deleted]

you already said it.....bearing(s)

[vvtr]

could be further than that.... could be the bearings in the gearbox...
check the wheel bearing first though - theyre only cheap & easy enough to replace.
another possibility is the suspension bushes / swing arm (engine mount) bushes - they tend to turn to mush over time and the whole back end will weave about at speed or when braking.

the difference with new bushes is very noticeable