|
|
Post by speedy1125 on Oct 23, 2011 13:54:09 GMT -5
......with no spark. What wire do i pick into for signal from flywheel?
|
|
|
|
Post by thunderkat59 on Oct 23, 2011 14:09:24 GMT -5
Hey Stroker95. . .I have an '08 Beamer that has had an electrical gremlin since day one. The one that goofed with my spark I traced back to the kill switch(i think) wire plug on the CDI. The wires were black and white with a blue stripe. Even though they're sort of epoxied in there, tugging and wiggling them got me spark again. I'm sure not too much help and very simplistic, but I always get easy stuff out of the way first. Please let us know what you find!!  |
|
|
|
Post by 90GTVert on Oct 23, 2011 16:08:54 GMT -5
|
|
|
|
Post by speedy1125 on Oct 23, 2011 23:05:46 GMT -5
Thanks ya'll!
Kat, No answer that comes from personal experience is a bad one!
We are having a really warm fall so far and the scoot repair work is going crazy! not to last but im going to get all I can!
|
|
|
|
Post by speedy1125 on Oct 23, 2011 23:17:09 GMT -5
Some background on this bike:
07 as i said and its been ridden, with no maintenance at all. 5000 miles on the OD. dirty and beat all to hell. Been sitting since just before Hurricane Irene. Dead battery and fuel line was about to fall apart, it actually did when i went to flexing it to check it out, sprang a leak right then.
Charged battery, new fuel line and filter today. Spins over good but no spark. thats all so far. Kid lives just down the street so im going to go get it or even push it here tomorrow.
|
|
|
|
Post by speedy1125 on Oct 24, 2011 4:31:35 GMT -5
If it ends up needing a cdi where would i find it? i dont see one on ebay for it
|
|
|
|
Post by 90GTVert on Oct 24, 2011 6:52:44 GMT -5
|
|
|
|
Post by speedy1125 on Oct 24, 2011 7:05:43 GMT -5
awesome thanx
|
|
|
|
Post by speedy1125 on Oct 24, 2011 14:28:19 GMT -5
whats up wih this?  |
|
|
|
Post by speedy1125 on Oct 24, 2011 16:40:36 GMT -5
must be rev limiter? all the wiring looks good otherwise. pick up coil ohms ok. could they have made the ignition coil any harder to get to?  |
|
|
|
Post by thunderkat59 on Oct 24, 2011 17:07:21 GMT -5
|
|
|
|
Post by kczukiman on Oct 24, 2011 21:17:45 GMT -5
I have a 04 beamer with only 340 miles on it and it died on me the other day. Same thing. It does have spark but very poor. I put a bbk 70cc on it about 150 miles ago.
|
|
|
|
Post by speedy1125 on Oct 25, 2011 11:12:40 GMT -5
orange wire which comes from the key, should i be seeing any voltage there? the meter jumps when i cycle the key. black to battery negative is good. meter pulses on blue/white to coil. coil is not open and primary windings ohm at 10.78 kohms. blue/yellow from pickup coil makes the meter jump like mad, an analog meter would be better for this.
the pickup coil ohms at 103.
Ignition coil has signal to coil when spinning over but nothing coming out of the primary winding even though its not open. plug cap is good.
right now im thinking bad coil, whos with me?
|
|
|
|
Post by speedy1125 on Oct 25, 2011 12:32:25 GMT -5
the beamer coil makes Midnight run so it aint that.
|
|
|
|
Post by thunderkat59 on Oct 25, 2011 17:37:45 GMT -5
PM sent
|
|
