|
Post by pitobread on Mar 24, 2020 13:02:51 GMT -5
I wouldn't say balance. I would say John is on point with crack propagated from the bottom of the key way sharp corner.
Corner radius are good!
|
|
|
Post by pitobread on Mar 23, 2020 21:21:31 GMT -5
Judging by the break and the color in the center, it was cracked for a while!
|
|
|
Post by pitobread on Mar 17, 2020 16:16:47 GMT -5
Drop the pilot down a size and see if the mid picks up Can also pull the clip down one spot to try and see what happens either good or bad.
Or get a needle with the same small diameter but a larger upper diameter and a more aggressive taper.
You CAN have it both ways.. it just takes a whole lotta effort... and needles.
|
|
|
Post by pitobread on Mar 12, 2020 19:11:31 GMT -5
I use automotive wheel acid to clean aluminum but I may have to try this boat cleaner! looks great!
|
|
|
Post by pitobread on Feb 18, 2020 17:01:58 GMT -5
RRGS make some I think. RPM as well. Prepare the wallet though... it will hurt.
|
|
|
Post by pitobread on Feb 16, 2020 12:25:54 GMT -5
CDI pickup.
Just swap it over and use any 2t ignition.
|
|
|
Post by pitobread on Feb 11, 2020 2:46:25 GMT -5
Don't forget to make the outboard bearing mount!
The inner bearing is like 8mm and there wasn't room to upsize it. the bearing I added in the front cover is also small ish. I don't think they will survive long without it and all that weight hanging off it. I mean it might but those clutches are pretty heavy compated to what was on there oem.
I forget what the bearing is but look up a piaggio kicker cover, or anything with the ID of the end spigot, shove it in a piece of tube and weld some brackets here and there.
I suppose you could even cut and hack a piaggio kicker cover back half as well...
|
|
|
Post by pitobread on Feb 9, 2020 12:28:47 GMT -5
Is yours an old sno scoot or a new one?
|
|
|
Post by pitobread on Jan 17, 2020 20:42:17 GMT -5
Last of the series.. It works.. Now to put in the hours to understand what it is saying!
|
|
|
Post by pitobread on Jan 15, 2020 20:08:34 GMT -5
Do a wheelie!
|
|
|
Post by pitobread on Jan 15, 2020 12:03:52 GMT -5
I've always thought about stuffing that dead space on CT manifolds..
Case volume is huge on these motors with such a long intake tract and all the oil pump business.
|
|
|
Post by pitobread on Jan 10, 2020 10:54:29 GMT -5
I have had a motobatt just straight die
Being agm if they get really low they are finicky to get a charge back in them too.
|
|
|
Post by pitobread on Jan 4, 2020 13:21:23 GMT -5
What diameter is the rotor?
You couldn't slot those enough to get it close.. it's way out
|
|
|
Post by pitobread on Jan 2, 2020 22:31:46 GMT -5
looks GR8
|
|
|
Post by pitobread on Dec 29, 2019 21:37:17 GMT -5
Is that a spare rear camino mag?
|
|